With this tool and two fingers, you can make all the necessary adjustments to the idle mixture on your CIS car.

Part#: 99-012-001

A quality tool for removing the inner CV bolts.

Part#: 10-012-008

This tool can be used to remove 12 point cylinder head bolts as well as the special bolt that retains the fifth gear on the 020 transmission mainshaft.

Part#: 10-012-012

These box end wrenches feature deep offset heads that allow it to fit into the recess at the top of the VW strut bearing.

Part#: 10-012-021

These box end wrenches feature deep offset heads that allow it to fit into the recess at the top of the VW strut bearing.

Part#: 10-012-022

Valve adjusting on the Rabbit, Scirocco, and Jetta 1 requires the use of a special tool to hold the cam followers in the down position in order to remove the shims for replacement.

Part#: 10-012-109K

Same as above, but made by Stahlwille Germany.

Part#: 10-012-12717

Valve adjusting on the Rabbit, Scirocco, and Jetta 1 requires the use of a special tool to hold the cam followers in the down position in order to remove the shims for replacement.

Part#: 10-012-12956

AST Shift Fork Tool 020 5th Gear.

Part#: 10-012-310K

Clutch Alignment Tool.

Part#: 10-012-341

Clutch Alignment Tool, 16V.

Part#: 10-012-342

Clutch Alignment Tool, Fox.

Part#: 10-012-343

This hex bit makes replacement of the front struts in a Mk4 VW hassle-free.

Part#: 10-012-411

Autotech 12V VR6 Camshaft Alignment Tool.

Part#: 10-012-460K

These uniquely designed tools are used in conjunction with part number 10.

Part#: 10-012-61600

These uniquely designed tools are used in conjunction with part number 10.

Part#: 10-012-62100

For late model cam belt idlers with pin holes.

Part#: 10-012-62400

These uniquely designed tools are used in conjunction with part number 10.

Part#: 10-012-63600

With the CIS injector remover and a screwdriver, you can remove the fuel injector nozzles with a minimum of problems.

Part#: 10-012-83400

For late model cam belt idlers with pin holes.

Part#: 10-012-86400

Allows easy removal of the special collar that retains the strut bearings on the strut of 4-cylinder Golf, Jetta and Corrado models from 1985-1995.

Part#: 10-012-87300

A highly specialized 22mm tool designed for removal of the Lambda sensor from your hard to reach manifold or header.

Part#: 10-012-88750

The Valve Spring Compressor can be used in or out of the vehicle to change springs.

Part#: 10-012-91400

Valve Seal removal Tool.

Part#: 10-012-92350

This tool keeps the pulley stationary while removing or installing the 3 bolts that retain it to the pump.

Part#: 10-012-96280

The VW steel spark plug boots are designed to seal and increase contact between the spark plug and spark plug wire.

Part#: 10-012-98180

Spark Plug Gap Gauge/Tool.

Part#: 99-012-910